Skip to main content
Geosciences LibreTexts

Reading: Volcanoes

WHERE VOLCANOES ARE LOCATED

Volcanoes are a vibrant manifestation of plate tectonics processes. Volcanoes are common along convergent and divergent plate boundaries. Volcanoes are also found within lithospheric plates away from plate boundaries. Wherever mantle is able to melt, volcanoes may be the result.


Figure 1. World map of active volcanoes.

See if you can give a geological explanation for the locations of all the volcanoes in figure 1. What is the Pacific Ring of Fire? Why are the Hawaiian volcanoes located away from any plate boundaries? What is the cause of the volcanoes along the mid-Atlantic ridge?

Volcanoes erupt because mantle rock melts. This is the first stage in creating a volcano. Remember from the chapter “Rocks” that mantle may melt if temperature rises, pressure lowers, or water is added. Be sure to think about how melting occurs in each of the following volcanic settings.

Convergent Plate Boundaries

Why does melting occur at convergent plate boundaries? The subducting plate heats up as it sinks into the mantle. Also, water is mixed in with the sediments lying on top of the subducting plate. This water lowers the melting point of the mantle material, which increases melting. Volcanoes at convergent plate boundaries are found all along the Pacific Ocean basin, primarily at the edges of the Pacific, Cocos, and Nazca plates. Trenches mark subduction zones, although only the Aleutian Trench and the Java Trench appear on the map in figure 1.

Remember your plate tectonics knowledge. Large earthquakes are extremely common along convergent plate boundaries. Since the Pacific Ocean is rimmed by convergent and transform boundaries, about 80% of all earthquakes strike around the Pacific Ocean basin (the ring of fire). Why are 75% of the world’s volcanoes found around the Pacific basin? Of course, these volcanoes are caused by the abundance of convergent plate boundaries around the Pacific.

The Pacific Ring of Fire is where the majority of the volcanic activity on the Earth occurs. A description of the Pacific Ring of Fire along western North America is a description of the plate boundaries.

  • Subduction at the Middle American Trench creates volcanoes in Central America.
  • The San Andreas Fault is a transform boundary.
  • Subduction of the Juan de Fuca plate beneath the North American plate creates the Cascade volcanoes.
  • Subduction of the Pacific plate beneath the North American plate in the north creates the Aleutian Islands volcanoes.

The Cascades are shown on this interactive map with photos and descriptions of each of the volcanoes.

This incredible explosive eruption of Mount Vesuvius in Italy in A.D. 79 is an example of a composite volcano that forms as the result of a convergent plate boundary:

Divergent Plate Boundaries

Why does melting occur at divergent plate boundaries? Hot mantle rock rises where the plates are moving apart. This releases pressure on the mantle, which lowers its melting temperature. Lava erupts through long cracks in the ground, or fissures.


Figure 2. A volcanic eruption at Surtsey, a small island near Iceland.

Volcanoes erupt at mid-ocean ridges, such as the Mid-Atlantic ridge, where seafloor spreading creates new seafloor in the rift valleys. Where a hotspot is located along the ridge, such as at Iceland, volcanoes grow high enough to create islands (figure 2).

Eruptions are found at divergent plate boundaries as continents break apart. The volcanoes in figure 3 are in the East African Rift between the African and Arabian plates.


Figure 3. Mount Gahinga, a mountain in Uganda, located in the East African Rift valley.

Volcanic Hotspots

Although most volcanoes are found at convergent or divergent plate boundaries, intraplate volcanoes are found in the middle of a tectonic plate. Why is there melting at these locations? The Hawaiian Islands are the exposed peaks of a great chain of volcanoes that lie on the Pacific plate. These islands are in the middle of the Pacific plate. The youngest island sits directly above a column of hot rock called a mantle plume. As the plume rises through the mantle, pressure is released and mantle melts to create a hotspot (figure 4).


Figure 4. (a) The Society Islands formed above a hotspot that is now beneath Mehetia and two submarine volcanoes. (b) The satellite image shows how the islands become smaller and coral reefs became more developed as the volcanoes move off the hotspot and grow older.

Earth is home to about 50 known hot spots. Most of these are in the oceans because they are better able to penetrate oceanic lithosphere to create volcanoes. The hotspots that are known beneath continents are extremely large, such as Yellowstone (figure 5).


Figure 5. Prominent hotspots of the world.

A hot spot beneath Hawaii, the origin of the voluminous lava produced by the shield volcano Kilauea can be viewed here:

How would you be able to tell hotspot volcanoes from island arc volcanoes? At island arcs, the volcanoes are all about the same age. By contrast, at hotspots the volcanoes are youngest at one end of the chain and oldest at the other.

VOLCANIC LANDFORMS AND GEOTHERMAL ACTIVITY

Volcanoes are associated with many types of landforms. The landforms vary with the composition of the magma that created them. Hot springs and geysers are also examples of surface features related to volcanic activity.

Landforms From Lava

Volcanoes and Vents

The most obvious landforms created by lava are volcanoes, most commonly as cinder cones, composite volcanoes, and shield volcanoes. Eruptions also take place through fissures (Figure 6). The eruptions that created the entire ocean floor are essentially fissure eruptions.


Figure 6. A fissure eruption on Mauna Loa in Hawaii travels toward Mauna Kea on the Big Island.

Lava Domes

When lava is viscous, it is flows slowly. If there is not enough magma or enough pressure to create an explosive eruption, the magma may form a lava dome. Because it is so thick, the lava does not flow far from the vent (figure 7).


Figure 7. Lava domes are large, round landforms created by thick lava that does not travel far from the vent.

Lava flows often make mounds right in the middle of craters at the top of volcanoes, as seen in figure 8.


Figure 8. Lava domes may form in the crater of composite volcanoes as at Mount St. Helens

Lava Plateaus

lava plateau forms when large amounts of fluid lava flows over an extensive area (figure 9). When the lava solidifies, it creates a large, flat surface of igneous rock.


Figure 9. Layer upon layer of basalt have created the Columbia Plateau, which covers more than 161,000 square kilometers (63,000 square miles) in Washington, Oregon, and Idaho.

Land

Lava creates new land as it solidifies on the coast or emerges from beneath the water (figure 10).


Figure 10. Lava hitting seawater creates new land.

Over time the eruptions can create whole islands. The Hawaiian Islands are formed from shield volcano eruptions that have grown over the last 5 million years (figure 11).


Figure 11. A compilation of satellite images of the Big Island of Hawaii with its five volcanoes.

Landforms From Magma

Magma intrusions can create landforms. Shiprock in New Mexico is the neck of an old volcano that has eroded away (figure 12).


Figure 12. The aptly named Shiprock in New Mexico.

Hot Springs and Geysers

Water sometimes comes into contact with hot rock. The water may emerge at the surface as either a hot spring or a geyser.

Hot Springs

Water heated below ground that rises through a crack to the surface creates a hot spring (figure 13). The water in hot springs may reach temperatures in the hundreds of degrees Celsius beneath the surface, although most hot springs are much cooler.


Figure 13. Even some animals enjoy relaxing in nature’s hot tubs.

Geysers

Geysers are also created by water that is heated beneath the Earth’s surface, but geysers do not bubble to the surface — they erupt. When water is both superheated by magma and flows through a narrow passageway underground, the environment is ideal for a geyser. The passageway traps the heated water underground, so that heat and pressure can build. Eventually, the pressure grows so great that the superheated water bursts out onto the surface to create a geyser (figure 14).


Figure 14. Castle Geyser is one of the many geysers at Yellowstone National Park. Castle erupts regularly, but not as frequently or predictably as Old Faithful.

Conditions are right for the formation of geysers in only a few places on Earth. Of the roughly 1,000 geysers worldwide and about half are found in the United States.

LESSON SUMMARY

  • Most volcanoes are found along convergent or divergent plate boundaries.
  • The Pacific Ring of Fire is the most geologically active region in the world.
  • Volcanoes such as those that form the islands of Hawaii form over hotspots, which are melting zones above mantle plumes.
  • Viscous lava can produce lava domes along a fissure or within a volcano.
  • Lava plateaus form from large lava flows that spread out over large areas.
  • Many islands are built by or are volcanoes.
  • Igneous intrusions associated with volcanoes may create volcanic landforms.
  • When magma heats groundwater, it can reach the surface as hot springs or geysers.

REFLECTION QUESTIONS

  • What skill does this content help you develop?
  • What are the key topics covered in this content?
  • How can the content in this section help you demonstrate mastery of a specific skill?
  • What questions do you have about this content? 

Contributors