14.1: The Stream System

The fundamental unit of study for fluvial processes is the drainage basin or watershed. A drainage basin is a portion of the Earth's surface that contains a main stream and its tributaries and is bounded by a drainage divide. The drainage divide represents the boundary between adjacent drainage basins and determines into which basin precipitation flows. There is no upper or lower limit to the size of a drainage basin. We can delimit the drainage basin of the Mississippi River as most of the area east of the Rocky Mountains. The main stream is the Mississippi River and its tributaries are rivers like the Missouri, Arkansas, and Wisconsin to name just a few. Or, at a more local scale we can delimit the Republican River basin found in central Kansas.

Figure \(\PageIndex{1}\): The Drainage Basin

Streams within the drainage basin are either perennial or intermittent in flow. Perennial streams flow all year. The base flow of these streams is provided by groundwater seepage into the channel. Intermittent streams only flow during wetter times of the year. Much of their flow is provided by surface runoff and when the water table is higher as a result of moist conditions. Tributary streams are small streams that enter into the main stream. Distributary streams are streams into which a river divides, for instance, in a river delta setting (see below). The upland between tributaries is called an interfluve.

Figure \(\PageIndex{2}\): Mississippi River Basin (Courtesy NOAA; Source)

The famous geographer John Wesley Powell recognized the value of the watershed concept in environmental planning. In 1878 Powell published his Report on the Lands of the Arid Region, which propose a strategy for settling the western United States without fighting over limited water resources. All Things Considered's Howard Berkes reports "Powell's knowledge of the region convinced him that water, or the lack of it, would be a major and ongoing problem in America's westward expansion." ► Powell proposed to organize settlements around water and watersheds because overuse or pollution would impact everyone in the watershed.

Figure \(\PageIndex{3}\): The Victoria Nile, near Murchison Falls in northern Uganda. (Courtesy K. Dunn, FAO_17389)

Most rivers become wider, deeper and transport more water as they flow downstream. Other streams are classified as exotic streams. Exotic streams are those that originate in a humid region but flow through an arid region, and as a result, they lose water going downstream. Such is the case of the Nile and Colorado Rivers. The headwaters of the Nile River is in the wet Ethiopian Highlands, and travels through the eastern portion of the Sahara Desert on its way to the Mediterranean Sea. Along its route, the river loses substantial amounts of water to evaporation. The same is true for the Colorado River. With its headwaters in the Rocky Mountains, it flows south and west towards the southwest desert of the United States. During its journey it loses nearly half its flow to evaporation. The Colorado used to flow to the ocean, but astonishingly it no longer does. The reason is that all remaining water has been diverted for agriculture and municipal water use.

Drainage Patterns

Figure \(\PageIndex{4}\): Aerial photograph illustrating typical dendritic drainage pattern developed in an area underlain by Gila conglomerate. Gila County, Arizona. (Courtesy USGS DDS21) Click image to enlarge

Over time, a stream system achieves a particular drainage pattern to its network of stream channels and tributaries as determined by local geologic factors. Drainage patterns or networks are classified on the basis of their form and texture. Their shape or pattern develops in response to the local topography and subsurface geology. Drainage channels develop where surface runoff is enhanced and earth materials provide the least resistance to erosion. The texture is governed by soil infiltration, and the volume of water available in a given period of time to enter the surface. If the soil has only a moderate infiltration capacity and a small amount of precipitation strikes the surface over a given period of time, the water will likely soak in rather than evaporate away. If a large amount of water strikes the surface then more water will evaporate, soaks into the surface, or ponds on level ground. On sloping surfaces this excess water will runoff. Fewer drainage channels will develop where the surface is flat and the soil infiltration is high because the water will soak into the surface. The fewer number of channels, the coarser will be the drainage pattern.

Figure \(\PageIndex{5}\): Dendritic drainage pattern

A dendritic drainage pattern is the most common form and looks like the branching pattern of tree roots. It develops in regions underlain by homogeneous material. That is, the subsurface geology has a similar resistance to weathering everywhere so there is no geologic control over the direction the tributaries take. Tributaries joining larger streams at acutes angle (less than 90 degrees).

Figure \(\PageIndex{6}\): Parallel drainage pattern

Parallel drainage patterns form where there is a pronounced slope to the surface. A parallel pattern also develops in regions of parallel, elongate landforms like outcropping resistant rock bands. Tributary streams tend to stretch out in a parallel-like fashion following the slope of the surface. A parallel pattern sometimes indicates the presence of a major fault that cuts across an area of steeply folded bedrock. All forms of transitions can occur between parallel, dendritic, and trellis patterns.

Figure \(\PageIndex{7}\): Trellis Drainage Pattern

Trellis drainage patterns look similar to their namesake, the common garden trellis. Trellis drainage develops in folded topography like that found in the Appalachian Mountains of North America. Down-turned folds called synclines form valleys in which the main channel of the stream resides. Short tributary streams enter the main channel at sharp angles as they run down sides of parallel ridges called anticlines. Tributaries join the main stream at nearly right angles.

Figure \(\PageIndex{8}\): Rectangular Drainage Pattern

The rectangular drainage pattern is found in regions that have undergone faulting. Streams follow the path of least resistance and thus are concentrated in places were exposed rock is the weakest. Movement of the surface due to faulting off-sets the direction of the stream resides. As a result, the tributary streams make sharp bends and enter the main stream at high angles.

View an offset stream along the San Andreas Fault in Google Earth.

Figure \(\PageIndex{9}\): Radial Drainage Pattern

The radial drainage pattern develops around a central elevated point. This pattern is common to such conically shaped features as volcanoes. The tributary streams extend the headward reaches upslope toward the top of the volcano.

Figure \(\PageIndex{10}\): Centripetal Drainage Pattern

The centripetal drainage pattern is just the opposite of the radial as streams flow toward a central depression. This pattern is typical in the western and southwestern portions of the United States where basins exhibit interior drainage. During wetter portions of the year, these streams feed ephemeral lakes, which evaporate away during dry periods. Salt flats are created in these dry lake beds as salt dissolved in the lake water precipitates out of solution and is left behind when the water evaporates away.